Boot blinky not working.
Most obvious (and annoying) question is:
Why did appear to work last week
and does not appear to work with the same forte lms now?
and does not appear to work with the same forte lms now?
- Obvious answer would seem to be wrong forte.bin downloaded.
- Backing up to this version did not help.
- See OpenOCD notes @ end of previous blog entry
- having a hard-code location for forte.bin can lead to wrong .bin file
Obvious tests are
- go back to a working version
- Summer 2010 with forte0.3 and larger eCos
- Works - but flashed only with Sam-ba so far
- is screen shot needed? Only in case blinky stops working with this version
- hg_LMS_SummerBkup now a hg repository
- committed all files to preserve everything this time
- Regression test of hg version works
Then switch out one piece at a time
- smaller eCos for larger eCos
- Problems in code not used by LMS forte (abandoned test for now)
- hg forte 0.4 for forte 0.3
- larger eCos for smaller eCos in current (2/16) forte
- too large if any FBs included
- boot blinky works with larger eCos
- working boot blinky so try again with smaller eCos
- eCos version used by DW had files 1 day newer than smaller eCos tested with
- boot blinky works with larger eCos
- HERE
- various lms code changes
- Does the lmsmain that only does boot blinky work everywhere?
- Incrementally add the code changes back into hg
- initially with old file structure.
- then new file structure
- blinky works in new structure
- add in avr_cntl
- add in FBs
- (only if doesn't work in new structure) move code around with incremental testing
- renames with incremental testing
Less obvious tests are:
- Is creation of forte.bin correct?
- since was part of setup before
- what was the forte file before?
- generalized OpenOCD -flash bat file so
- input directory and openocd directories are variables
- and .cfg file is in the same dir as the .bat file
- New forte code changes
- in Nov an rv and vr were exchanged, but think this change is in hg version
No comments:
Post a Comment